HVAC Duct Maintenance

The ductwork in your HVAC system transports treated air in the house. If you’re installing a new central air or heat pump system in your home, make sure the ductwork that will transport your new high-efficiency air conditioner meets the system’s requirements. Since all of the air passes into these ducts, any leakage or issues would detract from the overall impact of the device. Green Street HVAC-Furnace Repair Service¬†offers excellent info on this.

A successful technician can check all of the ducts while installing or diagnosing a device for Denver HVAC repairs. First and foremost, he wants to know if the current duct system will work with the newly built air handler. This will also reveal whether or not there are any leaks or other issues. Finally, to ensure protection, ducts should be insulated and routed in a specific manner. Checking for ductwork integrity is the term for this procedure.

There is some leakage in the typical residential HVAC system. So, in some cases, repairing the ducts will save you just as much money as purchasing a new high-efficiency device. If 20% of the air is leaking, the machine would have to work harder to compensate. As a result, your bills will go up, and you will need to get your Denver furnace repaired. So don’t be afraid to ask the HVAC technician to verify the ducts’ integrity. After all, it is their work.

Your HVACR device can require special attention in certain locations. The ductwork in wet areas or flood plains must be watertight. You’ll definitely need to repair the insulation after a flood, however if the ducts weren’t sealed, you’ll also need to replace the ducts and any other sections that were destroyed by infiltrating water. A duct that is watertight is also airtight.

Your Denver HVAC company will instal insulation around this well-sealed ductwork to keep it effective. Insulation also protects the interior of your home from temperature swings caused by hot or cold air passing through it. Moisture appears to accumulate at these temperature transitions. Water-saturated air below the dew point can sweat if it comes into contact with warm beams. This damages the ducts and can result in mould and mildew issues. To avoid this, ensure that the treated air is separated from the outside by a vapour barrier.